DK2 Power OPC504 조립 설명서 - 페이지 10

{카테고리_이름} DK2 Power OPC504에 대한 조립 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DK2 Power OPC504 14 페이지. 4 and 6 inch commercial chipper

Your Chipper is equipped with dual REVERSABLE cutting blades.

1. Turn engine key off, remove key and unplug the spark plug.

2. Open the large feed chute

3. Before removing the bolts that mount the blades place

paper towels in the area opening between the drum and

the drum housing. This will prevent bolts from dropping

into the drum housing.

4. Remove the first 4 bolts.

5. Before removing the last bolt be sure to support the blade

from sliding down into the drum. More paper towels or a

shop towel does a good job.

6. Remove the blade, reverse it to the new sharp edge and

reinstall it. Use only DK2 POWER OEM blades.

7. Use Loctite on the bolt threads when replacing bolts.

8. Use the supplied T-Handle tool to remove and replace bolts

9. Wear protective gloves, the blades are very sharp.

10. Remove the paper towels, any paper left in the chipper will

be cut up on the next running operation.