DK2 Power OPC566E 사용자 설명서 - 페이지 10

{카테고리_이름} DK2 Power OPC566E에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DK2 Power OPC566E 17 페이지. Tips, tricks & frequent questions
DK2 Power OPC566E에 대해서도 마찬가지입니다: FAQ 시트 (13 페이지)

페이지 인쇄
DK2 Power OPC566E 사용자 설명서

PART III: Operating the Wood Chipper

It may be helpful to better familiarize yourself with the features of your Wood Chipper
before beginning the steps outlined in this chapter.
WARNING
A. Read and understand all instructions, safety precautions, and/or warnings listed in
"PART I: General Safety Rules" before operating the WOOD CHIPPER. If any doubt
or question arises about the correct or safe method of performing anything found in
this manual, please contact DK2POWER.
B.
When operating the Wood Chipper, make sure you are standing in the safe operating
area (OPERATOR ZONE). Never place any part of your body into a position that
causes an unsafe operating condition.
C. Before loading and operating the Wood Chipper, always wear protective gear,
including safety goggles, hearing protection, tight-fitting gloves without draw strings or
loose cuffs, and steel-toed shoes.
D. Knowing the correct and incorrect methods of Chipping wood. Never using an incorrect
or unsafe method.
Starting
1.
Position your Wood Chipper on flat, dry ground.
Make sure the fuel shut-off valve is in the "ON" position.
2.
Move the choke control lever to the "CHOKE" position (should only be needed if the
3.
engine is cold).
Move the throttle control lever to the "FAST" position.
4.
Recoil Start: Turn the Ignition Switch to the "On" position. Grasp the recoil starter
5.
handle and slowly pull until you feel resistance. Let the cord retract a little bit then pull
the cord rapidly to start the engine. One or two pulls usually starts the engine.
6.
Electric Start: Turn and hold the Key in the start position until Engine starts then let
the Key return to run position.
Move the choke control lever (if used for cold engine) slowly back to the "RUN"
7.
position when the engine is running well.
8.
If the Wood Chipper has not been running (cold engine), warm up the engine by
running the engine at half throttle for 3 to 4 minutes, then advance the engine throttle
control to the maximum speed.
Part IV: Maintaining The Wood Chipper
10