Alula RE657 매뉴얼

{카테고리_이름} Alula RE657에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Alula RE657 12 페이지. Connect+ encrypted

The RE657 Touchpad

controlling the Connect+ security system. It is AC

powered and communicates with the panel wirelessly.

Features

• Real time status

• 7-inch color touchscreen

• Wall or table mounted

• 5-year warranty

• Battery backup

Installation Overview

1. Confirm the panel has a Wi-Fi DeviceLink card installed.

Installing the Wi-Fi DeviceLink Card

• Disconnect the panel's AC power and

backup battery.

• Install the Wi-Fi DeviceLink card in Slot 2

by carefully aligning the nylon retention

posts and the 8-pin connector while

pushing the card firmly until all posts are

fully seated.

• Reconnect the panel's AC power and

backup battery.

• Verify the Wi-Fi card LEDs are on.

2. Choose a mounting location within reach of the 10-foot power cable. (See page 8

for instructions on extending the wire).

3. Verify signal strength at the desired location before mounting it permanently.

Verifying Signal Strength

1. Make sure the panel is powered and the Wi-Fi DeviceLink card is installed.

2. Power up the Touchpad using the included adapter.

3. Verify the Touchpad displays "Select a Network." If it doesn't, press "Setup"

then "FACTORY DEFAULT."

4. If the signal strength displayed is less than 35, relocate Touchpad or Connect+

panel. If neither options are available, install an RE621 Touchpad Range

Extender.

RE657 Touchpad

Connect+

is an intuitive interface for

Encrypted

™

AC Power

Input

Slot 2

Backup

Battery