Aluprof AM45-10/17-ER-P 프로그래밍 매뉴얼 - 페이지 4
{카테고리_이름} Aluprof AM45-10/17-ER-P에 대한 프로그래밍 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aluprof AM45-10/17-ER-P 8 페이지.
Aluprof AM45-10/17-ER-P에 대해서도 마찬가지입니다: 프로그래밍 매뉴얼 (9 페이지)
페이지 인쇄
6. MANUAL SETTINGS OF LIMIT POSITIONS
UPPER
On the transmitter press
the „P2" button.
On the transmitter press
the „P2" button.
LOWER
Press the „DOWN" button
and hold for 2 seconds.
Press the „P2" button again.
If the motor doesn't accept programming, proceed to step 8.
4
PROGRAMMING MANUAL FOR AM45 MOTORS ER-P SERIES
The motor will make a short
move DOWN - UP.
The motor will make a short
move DOWN - UP.
Press STOP when courtan reache
limit position, correct the position
if needed.
The motor will make a short
move UP - DOWN.
Press the „UP" button and hold
for 2 seconds.
The upper limit position has been set.
On the transmitter press
the „P2" button.
The lower limit position has been set.
Press STOP when courtan reache
limit position, correct the position
if needed.
The motor will make a short
move DOWN - UP.
We reserve the right to any technical change.
Valid on 2022.01.27