Artos Denby M06860 설치 매뉴얼 - 페이지 5

{카테고리_이름} Artos Denby M06860에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Artos Denby M06860 6 페이지. Towel warmer hardwired version

5. Determine location of #6 outer rear cylinder by measuring the brackets attached to towel
warmer. Attach #6 cylinder to wall with hole for #7 locking screw facing down on the bot-
tom brackets and facing up on the top brackets.
6. Feed the wire from the towel warmer through the tube from the hardwire kit, and slide wall
plate onto the tube.
6. Attach upper brackets with locking screw #7, leaving lower brackets free at this time.
7. Connect wire from towel warmer to the wire coming from the timer. Use the instructions
provided with timer as a guide.
8. Push tube up towel warmer cord, over plastic sleeve, until it touches the hexagonal
chrome collar.
9. Push towel warmer onto the bottom brackets and screw mounting plate to the outlet box
using the screws provided.
10.Insert lower locking screws ( #7 ) . Snap on caps #8.
11.Reconnect power supply. Program timer using the instructions provided with the timer.
Towel warmer will take approximately 30 minutes to heat up to full temperature.
12.ENJOY!
INSTALLATION STEPS