Aluprof DC 448 프로그래밍 매뉴얼 - 페이지 2

{카테고리_이름} Aluprof DC 448에 대한 프로그래밍 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aluprof DC 448 4 페이지.
Aluprof DC 448에 대해서도 마찬가지입니다: 프로그래밍 매뉴얼 (4 페이지)

3. OPERATING MODE CHANGE

Press and hold the "P2"

button for 3 seconds. The

mode will be changed.

Manual mode - without time control function,

Automatic mode - with time control function,

Random mode - with time control function with a random selected time within ± 15 minutes to the set automatic time.

4. ACTIVE CHANNEL SELECTION

Switch to automatic or random

mode.

5. SETTING OF THE CURRENT TIME

Switch to manual mode

By pressing the "UP" or "DOWN"

buttons, settings of the

minutes can by change.

INSTRUKCJA PROGRAMOWANIA NADAJNIKA DC448

By reapitting procedure

will change mode between:

"Manual",

"Automatic",

"Random".

Select the chosen channel.

Press and hold the "MODE /

K-" button for 5 seconds. Hour digits

will flash.

Press the "MODE / K-" button.

Week day will flash.

Hold down the "OK / K +"

button for 3 seconds, the digit

of the disabled

channel will flash.

By pressing the "UP" or "DOWN"

buttons, you can

change the hour settings.

By pressing the "UP" or "DOWN"

buttons, settings of the

week days can by change.

Holding the "K-" button

again for 3 seconds turns on the

selected channel.

Press the "MODE / K-" button.

Minutes digits will flash.

To approve entered changes

press "OK/K+".

We reserve the right to any technical change.

Valid on 2022.02.09