Aluprof AC250-02 조립 및 프로그래밍 매뉴얼 - 페이지 5
{카테고리_이름} Aluprof AC250-02에 대한 조립 및 프로그래밍 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aluprof AC250-02 6 페이지. Under plaster switch with radio receiver
Aluprof AC250-02에 대해서도 마찬가지입니다: 프로그래밍 매뉴얼 (7 페이지)
페이지 인쇄PROGRAMMING MANUAL FOR AC250-02 UNDER PLASTER SWITCH WITH RADIO RECEIVER
10. PROGRAMMING OF THE FIRST TRANSMITTER.
Press and hold the "RIGHT"
button for 1 second.
The signal symbol will
flash.
11. PROGRAMMING OF THE ANOTHER TRANSMITTER
Additional transmitters can be programmed according to point 9.
For the AC116-04 transmitter, instead of the "UP" button, press the selected channel number twice.
Press and hold the "STOP"
button on the transmitter
already added for 6 seconds.
The signal symbol will flash.
12. MODE CHANGE (WITH OR WITHOUT SUPORT)
I
Press and hold the "RIGHT"
button for 1 second.
The signal symbol will flash.
II
Press and hold the "LEFT"
and "RIGHT" buttons
for 4 seconds.
Repeating of the procedure returns to the previous operating mode.
We reserve the right to any technical change.
Valid on 2021.05.27
Press the "UP" button on
the transmitter.
On the new transmitter
press the "UP" button.
Press the "STOP" button
on the transmitter.
After 2 seconds,
"SET" will be displayed.
The signal symbol
will flash quickly 3 times.
The signal symbol
will flash quickly 3 times.
The signal symbol
will flash quickly 3 times.
After 4 seconds, "INCh" (without
support) or "CONT" (with
support) will be displayed.
Release the buttons.
The transmitter has been
added.
The transmitter has been
added.
The setting has been saved.
The setting has been saved.
5