Aluprof AC250-02 조립 및 프로그래밍 매뉴얼 - 페이지 6
{카테고리_이름} Aluprof AC250-02에 대한 조립 및 프로그래밍 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aluprof AC250-02 6 페이지. Under plaster switch with radio receiver
Aluprof AC250-02에 대해서도 마찬가지입니다: 프로그래밍 매뉴얼 (7 페이지)
페이지 인쇄PROGRAMMING MANUAL FOR AC250-02 UNDER PLASTER SWITCH WITH RADIO RECEIVER
13. PROGRAMMING THE DIRECTION OF MOVEMENT
I
Press and hold the "RIGHT"
button for 1 second.
The signal symbol will
flash.
II
Press and hold the "UP" and
"DOWN" buttons for
4 seconds.
14. ERASING ONE TRANSMITTER.
Press and hold the "RIGHT"
button for 1 second.
The signal symbol will
flash.
15. ERASING ALL OF THE TRANSMITTERS.
Press and hold the "RIGHT"
button for 6
seconds. The signal
symbol will flash.
6
Press the "DOWN"
button on the transmitter.
After 2 seconds,
"SET" will be displayed.
On the transmitter
press the „P2" button.
After 6 seconds, the
signal symbol will
flash quickly 3 times .
The signal symbol
will flash quickly 3 times.
After 4 seconds,
"UP" or "dn" will be displayed.
Release the buttons.
The signal symbol
will flash quickly 3 times.
The transmitters have been
deleted.
The setting has been saved.
The setting has been saved.
The transmitter has been
deleted.
We reserve the right to any technical change.
Valid on 2021.05.27