Cutting Edge 100A MPPT 사용자 설명서 - 페이지 7

{카테고리_이름} Cutting Edge 100A MPPT에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Cutting Edge 100A MPPT 8 페이지. Charge controller

SCREEN GUIDE:

Settings that are adjusted will be automatically saved, even if power is removed.

From the home screen, short press "menu" to view the status of all parameters.

When you get to a setting you want to change, long press "menu" for 3 seconds to enter "edit mode". After

the setting is adjusted, to save: short press "menu" or just wait for the screen to time out.

b1, b2, b3, b4

Rev 20200515

"Innovative Renewable Energy Solutions"

Home Screen:

Default display which shows the battery voltage, if the solar panels are charging,

and if the load output is engaged.

PV OFF:

The voltage at which solar charging will be disconnected. PV OFF should be the

maximum voltage you want your battery/batteries to be charged. (Typ.

Note: this MUST be modified for LiFePO4 batteries!! Refer to your battery speci-

fications!

LOAD ON (Voltage):

The voltage at which the load output will be engaged (if allowed by time setting).

LOAD OFF:

The voltage at which the load output will be disconnected. This is a protective

setting to prevent the battery from overdischarging.

LOAD ON (Time):

The time at which the load output can be engaged. 24h means the load will al-

ways be on as long as the voltage doesn't drop below "LOAD OFF". 1-15h means

the load output will be engaged for this many hours after the charge controller no

longer detects the solar panel (sunset). 0h activates the "dusk to dawn" setting;

load will be set to engage at dusk and disengage at dawn.

These are preset settings and can be disregarded.

The other displays are status indicators/parameters.

Page 7