3M 710 사용 설명서 - 페이지 8

{카테고리_이름} 3M 710에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3M 710 20 페이지. Splicing rig
3M 710에 대해서도 마찬가지입니다: 브로셔 및 사양 (4 페이지), 사양 (4 페이지)

3.9 Wrap the group to be spliced with the other group

holder. Dress the pairs into the module body over

the colored peaks with the conductor ends exiting

towards the color code guide. Do not pull the

conductors tight to the back of the connector. Use

the error tester tool to check for correct conductor

placement.

3.10 Spread the conductors around the "T" bar without

disturbing them in the module body. Pull the "T" bar

up above the module body. Push the "T" bar forward

and down until contact is made with the conductors.

Pull the handle down to the stop, seating and cutting

the conductors in the module body. Remove the

excess conductors. Engage the handle into the

retaining clip, pull the "T" bar up, and place into the

open position.

3.11 Place a cap on the module body. Use finger pressure

to push down the cap to pre-engage it to the module

body. The cap latches should face the color code

guide. Pull the "T" bar up above the cap. Push the

"T" bar forward and down until contact is made with

the cap. Pull the handle down to the stop, seating the

cap into the module body. Engage the handle into the

retaining clip, pull the "T" bar up, and place into the

open position.

3.12 Push in the "L" clip to release the module and

remove from the splicing rig. The 25-pair straight

splice module is complete.

78-815-304--E