3M 710 사용 설명서 - 페이지 6

{카테고리_이름} 3M 710에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3M 710 20 페이지. Splicing rig
3M 710에 대해서도 마찬가지입니다: 브로셔 및 사양 (4 페이지), 사양 (4 페이지)

3.0 Straight Splicing using the 3M

3.1 Hold the handle to disengage the locked "T" bar

by turning the locking knob until the flat section

releases the "T" bar. Pull the "T" bar up and place

into the open position.

3.2 Set up the splicing rig on a support system with the

conductor group holders 1 1/2" (38mm) above the

cable group to be spliced.

3.3 Insert an index strip into the vertical side posts with

the cathedral windows facing the color code guide.

Push the "L" clip knob in to seat the index strip into

the channel and locate it under the "L" clips.

3.4 Secure a 25-pair group with the conductor group

holder. Dress the pairs into the index strip over

the colored peaks with the conductor ends exiting

towards the color code guide. Do not pull the

conductors tight to the back of the connector.

710 25-pair Modules

™

Flat

UNLOCKED

78-815-304--E