Alva GH301 사용 설명서 - 페이지 9

{카테고리_이름} Alva GH301에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Alva GH301 12 페이지.

CHANGING YOUR CYLINDER

Make sure you cylinder valve is closed (by turning it clockwise).

Allow the heater to fully cool before replacing the cylinder.

Unscrew the regualtor from the cylinder and lift the cylinder

holder. (Figure I)

Remove and replace the cylinder. ALWAYS check that the reg-

ulator-sealing washer (nose cone) is intact and in place before

reattaching the regulator to a cylinder. (Figure B - Page 3)

DO NOT attempt to remove the regulator while the heater is on

or if the cylinder valve is not closed.

Core

GOOD

BAD

Not enough air

BAD

Too much air

Fig.I

•

Always make sure the heater is

OFF and cool, with the cylinder

valve closed, before conduct-

ing any maintenance.

•

Your heater should be checked

once a year by a qualified

technician.

•

If faults are suspected or

detected, stop using the heater

and contact ALVA.

•

Clean the exterior and stor-

age area of your heater when

required to remove dust and

prevent lint build up.

•

DO NOT use abrasive products

to clean the heater; these may

damage the paint work.

•

While in operation the pilot

flame should be steady. If it

flickers or is yellow the heater

needs to be serviced. (Fig. I)