Alva GCS04 매뉴얼 - 페이지 8
{카테고리_이름} Alva GCS04에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Alva GCS04 12 페이지. Automatic gas cooker two burner stainless steel stove
Alva GCS04에 대해서도 마찬가지입니다: 매뉴얼 (12 페이지)
페이지 인쇄
The leak test must be carried out in a well-ventilated area, free
from any flames or other sources of ignition.
Connection
in assembly
Foamy
bubbles
indicate a
leak
Connections to be leak tested
Regulator into cylinder
Hose to regulator
Hose to appliance
Fig.14
FITTING AND CHANGING THE GAS CYLINDER
1. Before connecting the appliance to a gas cylinder,
always ensure that the rubber seal on the Regulator is in
position and in good condition, and blow out any dust from
the cylinder opening to prevent possible blockage of the jet.
2. Ensure that the gas cylinder is fitted or changed in a well-
ventilated location, preferably outdoors, away from any
source of ignition, such as naked flames and away from
other people.
3. Make sure that the gas cylinder is kept upright at all times,
screw the regulator onto the cylinder until it is fully engaged.
Hand-tighten only.
LEAK TEST
•
With the cylinder connected to
the stove. Open the cylinder
valve.
•
Brush the connections (stove
to cylinder) with a solution of
equal parts soap and water
(make sure it's foamy).
•
A stream of bubbles forming
indicates a gas leak. (See
Fig.14)
•
If bubbles appear, turn the
cylinder valve OFF (clockwise)
and disconnect the stove from
the gas cylinder.
•
Tighten the connection and
retry the leak test.
•
If you are unsure or if you
cannot tighten the connection,
place the cylinder outside in a
cool, well-ventilated area and
contact Alva on 086 100 ALVA
(2582).
•
A leak between the stove and
cylinder can lead to a high
pressure fire, which is very
dangerous and can result in
extensive injury or even death.
6
PRECAUTIONS
Leak test all
connections after each
tank refill
NEVER check for
leaks with a match or
open flame
Any LP Gas cylinder
not connected for use
must not be stored in
the vicinity of this or
any other appliance.