10 Bar LUMIX LX3 사용자 설명서 - 페이지 7

{카테고리_이름} 10 Bar LUMIX LX3에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 10 Bar LUMIX LX3 9 페이지. Camera underwater housing for panasonic lumix lx3

b. Install the camera into housing

d. fix the Converter Lens

There are o-rings on all the components of the port parts which should be installed according to the

procedures at 4.3.

4.7 Using External Strobes:

There is an option for Bulkhead SNM5 (Subtronic) or Bulkhead NKF5 (Nikonos).

Check the o-rings and connect the strobe sync cord to housing¡s bulkhead. Tighten the lock ring to secure

the cord in place. Make sue that the blank plug is secured to the bulkhead if no sync cord is connected.

5. Use & Care of Housing

5.1 Pre Dive Function Check.

Just before entering the water, make a habit of reviewing the proper steps to close the housing and connect

the bulkhead. Make a visual check of the O-ring seal. It is also useful to switch on the camera, and check

that controls e.g. on/off, zoom, shutter functions operate normally.

Check housing is closed



Check O-ring is in the groove between housing and Acrylic



Check battery and memory card status on the LCD display



Check control knob and zoom function



Check the Bulkhead is properly connected or blanked.



Always avoid submerging the housing in hot water for a prolonged time or a cleansing tank where

the water may be heated up by the sun.

c. Mount the Port Adaptor for housing

e. Install the Dome Port