10 Bar LUMIX LX3 Посібник користувача - Сторінка 7
Переглянути онлайн або завантажити pdf Посібник користувача для Аксесуари для фотоапаратів 10 Bar LUMIX LX3. 10 Bar LUMIX LX3 9 сторінок. Camera underwater housing for panasonic lumix lx3
b. Install the camera into housing
d. fix the Converter Lens
There are o-rings on all the components of the port parts which should be installed according to the
procedures at 4.3.
4.7 Using External Strobes:
There is an option for Bulkhead SNM5 (Subtronic) or Bulkhead NKF5 (Nikonos).
Check the o-rings and connect the strobe sync cord to housing¡s bulkhead. Tighten the lock ring to secure
the cord in place. Make sue that the blank plug is secured to the bulkhead if no sync cord is connected.
5. Use & Care of Housing
5.1 Pre Dive Function Check.
Just before entering the water, make a habit of reviewing the proper steps to close the housing and connect
the bulkhead. Make a visual check of the O-ring seal. It is also useful to switch on the camera, and check
that controls e.g. on/off, zoom, shutter functions operate normally.
Check housing is closed
Check O-ring is in the groove between housing and Acrylic
Check battery and memory card status on the LCD display
Check control knob and zoom function
Check the Bulkhead is properly connected or blanked.
Always avoid submerging the housing in hot water for a prolonged time or a cleansing tank where
the water may be heated up by the sun.
c. Mount the Port Adaptor for housing
e. Install the Dome Port
7