aion TITAN 매뉴얼 - 페이지 2
{카테고리_이름} aion TITAN에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. aion TITAN 11 페이지.
TABLE OF CONTENTS
1 Project Overview
2 Introduction & Usage
INTRODUCTION
The Titan Dynamic Drive is an adaptation of the legendary Fulltone
Drive was first released in 2005, itself a modified version of the Voodoo Labs Overdrive with several
added features and tweaks.
There were seven different official versions of V1 from its initial release until it was replaced by the V2
in 2017. Prior to the release of the "true" V2, these versions were referred to by the gear community as
V1, V2, V3, etc., but they've always been labeled V1.1, V1.2, V1.3, etc. inside the enclosure.
The Titan is a fully-overhauled version of our
18V charge pump in favor of a simplified layout. 18V mode can easily be added with our
PCB, which is compatible with this project. It also supports external 18V power like the original.
In place of this, we've added several new features, bringing in the most noticeable circuit tweaks from
V1.1 through V1.7 and using DIP switches to make them configurable. The result is a tonal workstation,
allowing you to tailor your own perfect version of the circuit.
We've included extensive documentation on the major differences between the versions and the switch
combinations that correspond most closely to each. The default parts list corresponds to v1.7, which is
the version that was in production the longest with around ~75,000 units manufactured.
USAGE
The Titan has the typical controls of a 3-knob overdrive:
• Drive controls the amount of gain pushed into the hard-clipping diodes.
• Tone controls the treble response via a passive filter.
• Volume controls the overall output.
There are also two toggle switches:
• Clipping (toggle switch) selects between soft clipping (overdrive), hard clipping (distortion) and no
clipping (clean boost).
• HP/LP (toggle switch) selects between "high peak" and "low peak" mode, which affects the range
and travel of the tone control. With Tone fully up, it just provides a slight volume boost, no different
than turning up the volume control a bit.
In addition, there are two internal 3-position DIP switches, which are described in detail on page 5.
TITAN DYNAMIC DRIVE
11 Licensing
original legacy
project. This version omits the on-board
®
OCD
®
. The Obsessive Compulsive
18V Bypass
2