DNP Supernova Core 설치 매뉴얼 - 페이지 2
{카테고리_이름} DNP Supernova Core에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DNP Supernova Core 4 페이지.
페이지 인쇄Warnings
Follow all assembly instructions. Incorrect assembly can lead to screen damage and invalidate
the dnp warranty.
Be careful not to kink the film during handling as it could make permanent marks in the film.
Keep sharp objects away from the film as they can scratch the film and destroy the optical
properties.
Please note that the backside of the film is more sensitive than the frontside and should thus
be handled more carefully.
Do not apply pressure to the screen material once it is mounted on the frame.
Required tools and materials
Phillips screwdriver
M6 Allen key
Rubber hammer
Level
Tape measure
2 appropriate mounting screws (and wall plugs)
Box contents
Check box for:
Installation manual (this document)
Rolled-up screen film (image area facing out)
Left/right frame pieces (short)
Top/bottom frame pieces (long)
Inner corner brackets
Adjustment pieces (fixture+bolt+hook)
Metal rods
Wall mounts
Corner covers (rear)
Cover strips (rear)
M6 nuts
M6x20 bolts (for wall mounts)
M6x20 Allen bolts (for inner corner brackets)
Assembly procedure
See illustration on last page
1.
Prepare a clean, flat surface to assemble the screen. Use a protective covering if
necessary. Determine how much space is needed for your size of screen.
2.
Unpack everything but the film roll and arrange the items nearby. Be careful not to
scratch the film when taking everything else out of the box.
3.
Place the frame pieces with the front side facing down. Note that if the working surface is
not properly cleaned or covered before use, particles can stick to the frame surface
material and in worst case damage it.
4.
Assemble the adjustment pieces (fixture+bolt+hook, see illustration on last page)