Blue Clean AR 1850 조립, 관리 및 사용 지침 - 페이지 14

{카테고리_이름} Blue Clean AR 1850에 대한 조립, 관리 및 사용 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Blue Clean AR 1850 16 페이지. Electric pressure washer

페이지 인쇄

PUMP SAVER

CARE AND MAINTENANCE

Turn unit off and disconnect the gun before adding

pump protector. Unscrew threaded top from bottle to

remove seal and reattach threaded top to bottle.

Remove black cap from bottle.

1) Place top of pump saver bottle onto the garden

hose adapter.

2) Secure pump saver bottle by turning in a clockwise

direction.

3) Turn the power on.

4) Squeeze bottle to help it into the pump.

TROUBLESHOOTING

If you have any questions regarding the product, please call customer service at 1-866-235-5112.

PROBLEM

Unit will not turn on.

The high pressure (HP)

hose will not connect/

stay connected to the

spray gun. Is this a

spray gun problem?

The unit is running but

there is no water flow.

95028_IM_ARBC_AR1850_EN_REV00_20181224.indd 14

CORRECTIVE ACTION

1. The GFCI module on the end of the power cord must be plugged directly into an outlet.

2. Do not use an extension cord.

3. With the GFCI Connected make sure the power switch is turned on.

Note: When power switch is turned on, the power washer will turn on by itself for 1-2

seconds and shut off. This is normal.

1. In most cases, the spray gun is not the problem. The problem is the rubber sleeve

covering the fitting at the end of the high pressure hose. It has likely slipped up toward

the metal tip. To fix: wiggle, twist and/or pull the rubber sleeve down until the entire tip

is visible plus an 1/8 in. of the metal fitting below the tip. Now try to insert the hose tip

into the spray gun. It should "click" into place and will not come out until the hose is

released by pushing in the lever on the underside of the gun. You may cut away the end

of the sleeve with a sharp knife if unable to move the sleeve down. Be careful not to cut

or puncture the hose.

2. Do not push in the release button when connecting the high pressure hose.

1. Power should NOT be turned on until water comes through the spray gun. Doing so will

damage the motor.

2. Check the water source.

3. Eject the nozzle from the lance to determine if clog is coming from the nozzle (If nozzle

is clogged, see nozzle cleaning instructions under "Cleaning nozzles").

4. Take off the lance and just spray out of the spray gun. This will indicate if the problem is

with the lance.

5. Check Garden Hose Adapter for loose connection and the filter for debris.

5) Turn power off when pump saver exits the machine's

water outlet.

Note: Instructions on Pump Saver Bottle are generic and

not model specific.

2018/12/25 下午3:58