FLAVIA SB100 사용자 설명서 - 페이지 5
{카테고리_이름} FLAVIA SB100에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. FLAVIA SB100 11 페이지. Brewer
FLAVIA SB100에 대해서도 마찬가지입니다: 사용자 설명서 (14 페이지)
페이지 인쇄
Before using
■ Please clean the tank and water contact parts.
How to install.
Push the drip tray in until a click
is heard.
How to insert the mesh filter.
Push onto the pipe at the bottom
of the tank until a click is heard.
Swish the active carbon filter
in water.
Insert the active carbon filter into the
separator.
How to insert the active carbon filter.
?
Push the
1
spring clip of
the active
carbon filter
into the hole
in the centre
of the
separator.
spring clip
To remove the filter, press the spring clip in and remove
from the separator.
Insert the separator inside the tank.
How to insert the separator into the tank.
?
1
Tank lip
?
2
3
?
? Turn the separator to the right
4
Marker
To remove the separator, turn it to the left and
remove in the reverse order.
Fill the tank with water up to the maximum
water level mark.
• As water enters the separator, you will here
the sound of air escaping.
Maximum water
level
Using the appliance for the first time or after a long time
2
? Clip the active carbon
filter into the separator
by securing the left and
right clips with the left
and right holders.
Holder
Clip
When inserting the separator
inside the tank avoid touching
the lip.
Once past the lip, bring the
separator into a horizontal
position.
Align the separator indent below
the marker inside the tank.
Mark inside
tank
Indent
until you hear the catch click.
Then fix the
marker into
the indent
on the
other side.
Tank
4
4
Plug in the appliance, switch the
power switch to the ON position
Switch off the appliance and leave to cool.
Remove the lid and drip tray.
? Pull diagonally
1
? Hold down the
2
away by
securing catch.
pressing the
Remove the lid
'pips' in the
by pulling by the
lid handle.
lid handle.
Lid
Securing catch
handle
Hold firmly and
pull out
Dispose of any remaining
hot water through the drain.
Notice
• Make sure to remove the drip tray before disposing of
unused hot water.
(Water contained in the drip tray can come into contact
with internal electric parts resulting in malfunction).
Notice
• Do not use the appliance near a
may result in malfunction).
source of fire (this may result in
• Do not leave unused heated
deformation of the casing).
water in the appliance. (Doing so
may result in corrosion to the
• Make sure that the separator is
tank and in an unpleasant
properly inserted in the tank.
odour).
(When not properly inserted, the
separator may fall out when
• Do not dispose of unused water
disposing of unused water. Also,
on the side of the control panel.
heated water may become
Always use the drain. (Not doing
tepid).
so can result in malfunction).
• Do not fill with water directly
• Empty drip tray reqularly. Use
from the tap. (Water may
caution when emptying, possible
overflow coming in contact with
hot contents.
internal electrical parts, which
and heat water.
Light comes on
when water has
heated.
How to remove
the lid.
To replace, push
diagonally in.
When closing, push
into position until
you hear a click.
How to remove
the drip tray.