Fleetminder platinum nxtg 설치 매뉴얼 - 페이지 5

{카테고리_이름} Fleetminder platinum nxtg에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fleetminder platinum nxtg 12 페이지.

4. Connect the GSM antenna to the unit.

• The silver connector on the unit is reserved for the GSM

antenna.

5. Install a suitable place for the Panic switch.

• In most cases the switch is located on the kick panel.

• Please ensure the location will avoid accidental triggering

6. Run the Black wire to a good ground location.

• Usually the car body is an earth, so a good metal bracket is

suitable. Test the earth is solid using a Multimeter.

• Make sure it does not change state when the IGN is turned on, or

when the lights are turned on. (Some vehicles change state from

ground to +12V on some wires when the lights are turned on)

7. Run the Yellow wire to an IGN trigger, if online tracking is

required.

• If online tracking is required, Input 1 is reserved for IGN trigger.

• Run the Yellow wire to an IGN trigger which has to be 12V+ or

24V+. (Can be found on the ignition switch.)

Note: Use IGN wire that does not drop from 12V+ under crank condition.

8. Connect other Inputs and Outputs to their desired triggers

before connecting the Red wire to 12V+ or 24V+ (Please refer to

the wiring diagram for further wiring colours.)

• The outputs are all Negative Triggers (GND) and are rated to

300mA max.

• In most cases relays will have to be used for the Outputs.

• Suggested Outputs: Door Unlock, Flash Lights, Disable Starter Motor.

• Input 1 is Positive trigger (12V+ or 24V+)- Reserved for IGN

• Input 2 is Negative (GND) trigger.

fleetminder Installation Manual

Installation Manual

Page 3