Etac 1600017 사용자 설명서 - 페이지 6

{카테고리_이름} Etac 1600017에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Etac 1600017 12 페이지.

Etac 1600017 사용자 설명서
Molift MRS Duo / www.etac.com

Supplied parts

2x
4x
4x
4x
4x
1x
Make sure the following parts are included in the
package.
Beware of sharp edges at the ends of
the boom.

Mounting Foot

1. Lay post on the floor.
2. Use the longest M10x50 bolts.
3. Use allen key, located in top of post) to screw
in bolts.
4. Align the foot, and screw in both bolts.
5. Make sure both bolts are properly fastened.
Important! Use the longest bolts
(M10x50)when installing foot,
shorter bolts may cause collapse.

Assembly

2x
2x
2x
2x
2x

Mounting boom to post

1. Slide washer and post in to boom.
2. Insert bolts trough holes and washer in boom.
3. Use allen key, (located in top of post) to screw
in bolts.
4. Make sure both bolts are properly fastened
Do not stand under the boom
when mounting, use a stand or
similar to support the boom.
Mounting second post, trolley and end stop
1. Slide end stop, trolley and end stop into boom
in described order.
2. Slide washer and post in to boom.
3. Insert bolts trough holes and washer in boom.
4. Use allen key (located in top of post) to screw
in bolts .
5. Make sure both bolts are properly fastened.
Fasten end stops temporary during assembly. Must
be fastened properly with tools after adjustment
of height.
Important! Fasten end stops to
prevent trolley from moving when
adjusting post heigts. Moving
trolley can unintendedly hit the
operator.
5