Etac Molift Air Series 사용자 설명서 - 페이지 9

{카테고리_이름} Etac Molift Air Series에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Etac Molift Air Series 15 페이지.

Mounting Suspension

1. Align suspension in connection point.

2. Push button on locking pin and insert all the

way through.

3. Make sure locking pin is properly fastened

4. Push button and push bolt from opposite side

while holding in button to remove locking pin.

Emergency Stop

Activation and reset of emergency stop:

Pull to activate emergency stop. The button will

come out, and hoist will stop.

Push with finger or use tube on cord to push but-

ton back in to reset emergency stop.

Electrical Emergency Lowering

Pull and hold to start lowering. Hold until user is

lowered and can be released from suspension.

Only for emergency use when hand

control does not work! Stop before

full band is out, or lifting band will

be winded the wrong way and go

upwards.

Manual Emergency lowering

Allen key or bit for power drill can be found inside

the lifter. Remove cover to locate.

Push down and press cover outwards with a flat

screwdriver in the two slots to open cover. Turn

the "Brake Release" handle down.

Locate sticker over the hole for manual emergency

lowering. Punch hole or remove sticker and insert

tool. Rotate counterclockwise to lower lifting belt.

Using a power drill is recommended.

Lifter must be sent to service after performing

manual emergency lowering.