DOD Technologies ChemLogic CL8 사용자 설명서 - 페이지 6

{카테고리_이름} DOD Technologies ChemLogic CL8에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DOD Technologies ChemLogic CL8 7 페이지. Continuous gas monitor

페이지 인쇄

2.2 Tubing

NOTE : The two bundles of tubing labeled 'inlet' and 'out' each contain 8 tubes

which must be attached to the pyrolzers. The left pyrolyzer is points 1-4 and the

right side is points 5-8. The pyrolyzers are mounted opposite so the inlet and

out tubes are opposite each other on each unit.

First carefully attach inlet

tubes 1-4 to the top

connectors of the left

pyrolyzer.

Now repeat the procedure for

the inlet of points 5-8 on the

bottom of the right pyrolyzer.

Connect the outlet tubes for

points 1-4 to the bottom of the

left pyrolyzer.

Connect the outlet tubes for

points 5-8to the top of the

right pyrolyzer.

DC-ITD-CL4-CL8MANPYRO_A

REV 8/25/2022

Using the labels on the

tubing connect the inlet

tubes to points 1 thru 4.

Point 1 is in the top-left-

back sequentially thru point

4 in the top-left-front.. Fully

insert the tubes securely in

to the Pyrolyzer fitting.

Point 5 is in the bottom-

right-back sequentially

thru point 8 in the bottom-

right-front. Fully insert the

tubes securely in to the

pyrolyzer fitting.

Point 1 is in the

bottom-left-back

sequentially thru

point 4 in the

bottom-left-front.

Point 5 is in the top-

right-back

sequentially thru

point 8 in the top-

right-front.

CL4 & CL8 Manual

DODtec.com

815-788-5200