Clinton 1020 조립 지침 - 페이지 3

{카테고리_이름} Clinton 1020에 대한 조립 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Clinton 1020 4 페이지. With adjustable backrest or non-adjustable top

Position leg in the leg brace with H- brace hole

facing inward. Attach the leg using

and

" nut. Finger tighten nut now, and fully

tighten after step 6 is completed. Repeat with remaining

legs.

Position the H-braces with finished edge toward

top with the cut-out slot facing toward the

inside of the table and attach using the four (4)

" truss head screws.

Insert the barrel bolts into the holes at each end

of the spanner. Make sure the threaded hole

in the bolt is position to accept the pan head

screw that will be inserted through the H-brace.

" washer

tighten until the screw catches the threads in

the barrel bolt, then secure with a screwdriver.

with the adjustable headrest. Apply 4 adhesive backed hook

strips to top edge of H-braces. Place the full-length shelf

on the spanner with the loop strip underside over the hook

strips on the braces.

FOR SAFETY PURPOSES, TAKE TIME TO CHECK ALL

SCREWS, BOLTS AND NUTS TO INSURE THAT

THEY ARE SECURELY TIGHTENED AND THAT THE

Insert the 2

" pan head bolts

through each H-brace and into the

barrel bolts in the spanner. Finger

Return to each corner leg and finish

tightening each nut. DO NOT OVER

TIGHTEN.

1020 SHELF ASSEMBLY

Invert the table to an upright position on all

four legs, using caution when inverting the end

TABLE HAS BEEN PROPERLY ASSEMBLED

ACCORDING TO THESE INSTRUCTIONS.

PROCEED TO STEPS 9 & 10 ON BACK COVER

FOR MODELS 1030 & 1013

Adhesive-Backed Hook Strips