Clinton 84100 사용자 설명서 - 페이지 6

{카테고리_이름} Clinton 84100에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Clinton 84100 11 페이지. Bariatric open base power tables combine load and force capacity: 550 lbs. (249 kg)

페이지 인쇄

LEVELING

For optimum performance an patient safety, all Clinton

Open Base Power Tables should be on a clean, level

non-slip surface.

Once the table is in the desired location, level the table

by adjusting the four leveling feet on the table.

Turn the feet counter clockwise to decrease the height

and clockwise to increase the height of the leg.

Make certain that the table is level in all directions and

that it does not wobble or rock.

OPERATION

CLEAN BEFORE USING (All

It is important to thoroughly clean tables according to facility standards before it is put into service. See cleaning

suggestions on page 8 of this manual.

HI-LO OPERATION (All

Clinton Open Base Power Tables shown in this manual control the up and down functions of the table with a

standard foot controller. (Note: Optional hand controller is available at additional cost.)

Press the down button on the foot controller with slight even pressure and the table will slowly go down to

minimum level. Slight even pressure on the up button will slowly raise the table to maximum height.

ADJUSTABLE BACKREST (

If the table is equipped with an adjustable backrest with a pneumatic cylinder, the angle of the backrest is

controlled from either side of the table by an actuator. Rotate the actuator towards the backrest to adjust. Always

use your hand on top of the upholstered top to move the backrest up or down. The backrest cylinder is

pressurized in the up position only and requires force to return it to the down position.

Backrest Actuator

Models )

Models 84200 & 84430 only)

Backrest Cylinder

Adjusting Nuts

Backrest

Cylinder