Acqua Brevetti BravoFIL Plus 설치 및 운영 매뉴얼 - 페이지 4

{카테고리_이름} Acqua Brevetti BravoFIL Plus에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Acqua Brevetti BravoFIL Plus 9 페이지.

MAN055 – REV. 0 DATE: 11.01.2011

3.0 FILTER INSTALLATION

3.1 GENERAL INSTALLATION RULES

According to Italian Regulation the installation of the filter must be done by a qualified company that should provide a

certificate for correct installation. The installer should leave a technical document containing clear indications about

fittings, zone valves, sampling taps, drainage points and any other element pertaining assembly of the appliance. Such

documents should be attached to the user's manual and consigned to the customer.

Install the filter observing all applicable local installation regulations, general guidelines and technical specifications.

The semi-automatic cleaning filter PuliFIL protects hydraulic systems from foreign bodies.

Attention!

Check for the right connections of water inlet and outlet. The entrance and exit of water must be

concordant with the direction of the arrow printed on filter brass head.

Before installation, please observe all applicable installation regulations, general guidelines and technical

specifications.

Before installation clean thoroughly pipes and equipments installed before the filter to eliminate any foreign

body.

It is advisable to install shut-off valves immediately up-stream and down-stream the unity

It is advisable to install a by pass valve to by-pass the filter during maintenance

It is advisable to install sampling points up-stream and down-stream the filter to verify efficacy of filtering unit.

The installation site must be protected against frost and must guarantee the protection of the unit from all types

of chemicals, paints, heating oils, lees, solvent vapours, heat sources above 40°C and direct sunlight.

Leave sufficient space for unscrew filter bowl.

After installation verify for water leakage

3.2 HYDRAULIC CHECKS AFTER THE INSTALLATION

After opening water to filter unit please verify for water leakage:

1. Verify that the installation allows maintenance

2. Verify the presence of a by pass circuit to exclude the pump from main water supply line during servicing;

3. Verify the sampling points upstream and downstream the filtering unit;

4. Verify that the installation is compliant with local installation regulations, general guidelines and technical

specifications.

4.0 GENERAL INSTALLATION FLOW SHEET

Legenda

1. Cold water inlet; 2. Water flow meter; 3. Back flow prevention device; 4. Zone valve; 5. Sampling tap; 6. By-pass

valve; 7. BravoFIL filter; 8. Cold water outlet; 9. Discharge.

Acqua Brevetti 95 s.r.l.

DRAFT BY: U.T.

PAG. 4 DI 9