Clipcomm BS-A101 빠른 시작 매뉴얼 - 페이지 10

{카테고리_이름} Clipcomm BS-A101에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clipcomm BS-A101 13 페이지. Clipcomm bs-a101 voip phone quick start guide

[Important Check Points before Phonizer-CFA evaluation]

The following items must be checked before starting Phonizer-CFA evaluation.

① Remove the power cable from your PDA and make it sure that the PDA is off the

cradle before the calling test.

② When the power is being fed to the PDA, the voice quality may be degraded due to

60Hz humming noise.

③ Ensure that the remained battery power level is over 80% during the call test.

④ Battery power level of 50% or below may cause the power failure of the Bluetooth

module.

⑤ When the remained battery power level is 50~80%, some noise may occur during the

call.

⑥ When you are using the PDAs, such as iPAQ3870, iPAQ3970, and iPAQ5450, with

built-in Bluetooth or wireless LAN modules, make it sure to disable the built-in

Bluetooth or wireless LAN module on the PDA. Otherwise the Phonizer-CFA software

will try to communicate with the built-in Bluetooth or wireless LAN module instead of

Clipcomm's Bluetooth CF card (CBT-CFA).

⑦ Insert CBT-CFA properly into the slot of expansion pack.

⑧ Please use only the earset provided by Clipcomm.

⑨ Insert the earset completely into the side hole of CBT-CFA card.