DOEPFER A-100 Series 매뉴얼 - 페이지 4
{카테고리_이름} DOEPFER A-100 Series에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DOEPFER A-100 Series 6 페이지. Analog modular system, connecting the breakout module to the main module
DOEPFER A-100 Series에 대해서도 마찬가지입니다: 사용 설명서 (8 페이지), 매뉴얼 (16 페이지), 사용자 설명서 (12 페이지), 조립 및 배선 매뉴얼 (6 페이지), 매뉴얼 (8 페이지), 매뉴얼 (8 페이지), 연결 (8 페이지)
페이지 인쇄
A-129 /5
Voiced/Unvoiced Detector
$ Unvoiced Input
This unvoiced carrier signal input $ is used to patch
in the sound source you wish to use for the carrier
signal for unvoiced sounds.
As a rule, you'd tend to use the output from a noise
module (A-117, A-118), a high-frequency sawtooth
wave, or the 6 Oscillator output from an A-117 mo-
dule.
% Voiced Input
This voiced carrier signal input % is used to patch in
the sound source you wish to use for the carrier
signal for voiced sounds.
Usually, you'd tend to find a low-mid frequency VCO or
mix of several VCOs doing this job.
& Voiced / Unvoiced Output
Depending on the status of the voiced/unvoiced detec-
tor switching, output & relays the input signal from
socket $ or %.
4
System A - 100
5. User examples
Vocoder block diagram including A-129 /5
The way the A-129/5 should be patched into the whole
vocoder system is shown in fig. 2 (see next page).
Smoothing Voiced / Unvoiced transitions
Whereas the A-129/5's internal switch produces an
abrupt change from voiced to unvoiced carrier and
vice versa, it's possible to patch the gate output to a
slew limiter, invert one of the carrier VCAs, and pro-
duce a smooth transition.
Gate Out
A-129 /5
A-170
fig. 1: smoothing the change of carrier signals
doepfer
A-117
A-130
A-118
A-110
A-130
A-111
A-175
A-138
to
Speech Input
of A-129 /1