DOEPFER A-100 Series 매뉴얼 - 페이지 3

{카테고리_이름} DOEPFER A-100 Series에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DOEPFER A-100 Series 6 페이지. Analog modular system, connecting the breakout module to the main module
DOEPFER A-100 Series에 대해서도 마찬가지입니다: 사용 설명서 (8 페이지), 매뉴얼 (16 페이지), 사용자 설명서 (12 페이지), 조립 및 배선 매뉴얼 (6 페이지), 매뉴얼 (8 페이지), 매뉴얼 (8 페이지), 연결 (8 페이지)

페이지 인쇄

doepfer

3. Controls

1 Gain

Use control 1 to set the level of input gain for the

speech signal at socket !.

2 Treble Boost

Control 2 is used to increase the level of the high

frequencies in the speech signal input. Often, using

this control makes speech more easily intelligible.

To produce the best results, please also look

at the general instructions (chapter 5) in the

manual for the main vocoder modules, A-129

/1 and A-129 /2.

3 LED

This LED indicator 3 shows the status of the swit-

ching in the voiced / unvoiced detector:

• LED on :

"Unvoiced"

• LED off :

"Voiced"

System A - 100

4. In / Outputs

! Speech Input

The speech signal is patched into Speech-input !.

" Speech Output

Speech output " puts out the amplified and equalised

(treble-boosted) speech input signal. This output is

patched to the speech input socket on the A-129 /1

analysis module.

§ Gate Output

Gate output § puts out a gate signal, depending on

the status of the voiced/unvoiced detector:

• "Unvoiced" (LED 3 on) : "high"

• "Voiced" (LED 3 off) :

You can use this gate signal for more elaborate sound

manipulation (see 5. User examples).

Voiced/Unvoiced Detector

"low"

A-129 /5