DOEPFER d3m 사용자 설명서 - 페이지 10

{카테고리_이름} DOEPFER d3m에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DOEPFER d3m 12 페이지. Organ keyboard

페이지 인쇄

Example: Number = 5, Bank = 3

The resulting programm number is 5 – 1 + 12 x (3 –1) = 4 + 24 = 28.

The last available program change number is 119 (number #12 in bank #10). The program

change numbers 120...127 are not available. In practice the Midi program number generated

by the number and bank buttons is of minor importance as one will remind the number and

bank buttons used for a certain sound but not the program change number that is assigned

to this sound.

•

EVB3 Mode

This mode is planned for the combination of d3m with the organ emulation EVB3 of

Emagic. This software is e.g. included with Emagic's Logic.

Remark: The EVB3 has to be set to the RK mode. For details please refer to the EVB3

user's manual.

In this mode the number buttons transmit the Midi note messages 24 – 35. They correspond

to the inverse colored lowest octave of the original B3 and work like an additional lower

octave of the d3m manual. If a normal Midi sound generator is connected to the Midi output

of d3m in this mode the number buttons generate normal tones and no program change is

activated. Consequently this mode makes sense only in combination with the EVB3 as only

this software uses the Midi note numbers 24 – 35 to change the program.

The bank buttons are used in the EVB3 mode for certain functions that cannot be stored in

the EVB3 presets. These functions are controlled "live", i.e. while playing on the keyboard.

The following table shows the function of the bank buttons in the EVB3 mode :

Bank

Function

Vibrato UpperManual On/Off

Vibrato LowerManual On/Off

Vibrato C1

Vibrato C2

Vibrato C3

Percussion On/Off

Percussion 2

Leslie Slow (Chorale)

Leslie Off (Brake)

Leslie Fast (Tremolo)

•

Remote Mode

This mode is planned for the combination of d3m with special software (e.g. Ableton Live). In

combination with normal Midi sound generators this mode does not make sense.

In the Remote mode the number buttons transmit the Midi note messages 0-11 and the bank

buttons the Midi note messages 14-23. In this mode the LEDs are not managed by the the

d3m but have to be controlled by the external software via incoming Midi note messages (0-

11 for the LEDs assigned to the number buttons and 14-23 for the LEDs assigned to the the

bank buttons). All other functions (e.g. foot switch, foot controller) are the same as for the B4

mode.

Consequently this mode requires an external software that allows to assign certain functions

to the Midi note messages 0-11 and 14-23 and to control the LEDs of the d3m via Midi note

messages in a suitable way. For example Abletons's Live can be used for this purpose.

d3m

Page 10

Remark

toggle function

radio buttons

toggle function

radio buttons

User's Guide V1.2