DOEPFER A-103 VCF 6 매뉴얼 - 페이지 3

{카테고리_이름} DOEPFER A-103 VCF 6에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DOEPFER A-103 VCF 6 6 페이지. System a - 100

doepfer

3. Controls

1 Frq.

With this control you adjust the Cut-Off Frequency f

above which the filter attenuates all frequencies. At 10,

the filter is fully open. The more you turn down this

control, the more the high frequencies are filtered. The

sound becomes mellower and less bright (see Fig. 1)

until at 0 the filter is completely shut, and there will be

no output signal at all.

2 CV 2 • 3 CV 3

For voltage control or modulation of the cut-off fre-

quency, use these CV inputs " and/or § (see Fig. 1).

Use attenuators 2 and/or 3 to adjust the control

voltage level.

4 Lev.

Use this attenuator to control the amount of signal

entering the filter input $.

If the filter's output distorts, turn this control

down, unless you deliberately want the sound

System A - 100

Out

Fig. 1: Frequency response of the A-103

5 Res.

With this control you adjust the filter's resonance

(emphasis, Q ) - the parameter which emphasises the

frequencies around the cut-off point f

maximum setting, the filter becomes so resonant that it

goes into self-oscillation, and starts behaving like a sine

wave . You can take advantage of this effect, and use

the VCF as an additional oscillator.

18dB Low Pass A-103

Frq. / CV

Res.

Freq.

. Close to its

as a spe-

cial effect.