Cannondale Alloy Road Disc 빠른 시작 매뉴얼 - 페이지 5

{카테고리_이름} Cannondale Alloy Road Disc에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cannondale Alloy Road Disc 16 페이지.

Step 1. Install your handlebars.

Using the included Allen wrench, loosen and remove the bolts and

faceplate from the stem. The stem connects the handlebar to the

fork. Set the bolts and faceplate aside together, so you don't lose

anything.

Insert the handlebar into the stem and verify the brake hoses and

shift cables wrap around the frame cleanly, without kinks to any of

the lines.

Loosely reattach the faceplate to the stem. Take care to not tighten

one bolt more than another. Your goal is a consistent gap between

the stem and faceplate.

Center the handlebar in the stem using the markings on the bar, then

roll it back into a comfortable position. Lightly hand-tighten the stem

bolts using the Allen key, ensuring there's an even gap between the

stem and faceplate. We'll fully tighten these later.

SET-UP

STEP 1

STEP 2

STEP 3

STEP 4

PRE-RIDE CHECK