ClipperCreek HCS SERIES 설치 매뉴얼 - 페이지 9

{카테고리_이름} ClipperCreek HCS SERIES에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ClipperCreek HCS SERIES 9 페이지. Quad-mount kit. innovative infrastructure for electric and hybrid vehicles
ClipperCreek HCS SERIES에 대해서도 마찬가지입니다: 설치 매뉴얼 (20 페이지)

페이지 인쇄
Figure 16: Installing the Cover Plate
12. Install the Holster
The holster, which is included with the station, is to
stow the vehicle connector. To install, follow the steps
below.
Place a #8 washer around the shaft of each of the two
•
(2) 8-32 pan head screws.
Secure the Holster to the Mounting Plate as shown.
•
For an installation with two chargers affixed to the
•
same post, repeat the previous steps for the opposite
side.
Figure 17: Mounting the Holster
HCS Series EVSE Pedestal Installation Guide
13. Mounting Two Chargers to the Pedestal
For an installation with two chargers affixed to the same
post, repeat the previous steps 7 through 11 for the opposite
side.
14. Wrap and Stow the Vehicle Connector
Loosely wrap the cable around the HCS as shown in
•
Figure 18.
Stow the Vehicle Connector in the holster. The button
•
does not need to be pressed, simply insert until you
hear the click to lock in place.
Verify the safety of the installation prior to turning on
•
the circuit breaker.
Refer to the Charging Station User's Guide for further
•
operational and maintenance information.
Page 9 of 9
Figure 18: Wrap and Stow the Connector
Visit us at
www.clippercreek.net
HCS Series EVSE Pedestal Installation Guide
Version 4, April 2016