Dog Runner Tracks 사용자 설명서 - 페이지 12

{카테고리_이름} Dog Runner Tracks에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dog Runner Tracks 18 페이지.

1.3 TIME

1.3.1 In exercising mode: TIME read out display range 0:00 – 99:59 (Minutes: Second) , over

99:59 will retrun to ZERO to start new countdown.

1.3.2 In setting mode: Setting range 5:00 – 99:00, set stepping 1.00 ,TIME icon will flash when

set countdown mode.

1.4 CALORIES

1.4.1 In exercising mode: CALORIES read out display range 0-999, over 99:59 will retrun to

ZERO to start new countdown, CAL ICON will flash.

1.4.2 In setting mode: Setting range 5:00 – 99:00, set stepping 1.00, TIME icon will flash when

set countdown mode.

2. Computer Operation Instruciton :

2.1 Operation Instruction – Power on display -

2.1.1 After turn on machine without putting on safety key, all data display as "- - -" beeper makes

"beep" sound.

2.1.2 After put on safety-key, SPEED window display shows "Version No.", other window display

with flash for 1 second, then all data display resume to ZERO.

2.1.3 Turn on machine display: recognize program, under countdown mode, press "START"

button, widow display shows 3 – 2 – 1 with beep to count down then machine starts.

2.2 Button Functions:

2.2.1 START - At the time of treadmill stand-by mode, Program mode and Time countdown

mode, press the START button, console displays set speed. Treadmill starts aftter

countdown for 3 seconds.

STOP - During treadmill running when press STOP button, the treadmill will decrease

speed until stop. After machine stop completely, the treadmill returns to stand-by mode and

all workout data return to zero.

2.2.2 PROGRAM button - Under stand-by condition, this button can alternatively choose manual

mode or Pre-set program. Pre-set programs have P01 – P04.

2.2.2.1 Default time countdown mode: TIME window display"30 :00" and flash, Use "SPEED"

button +/- to adjust time setting, range: 5:00-99:00, each adjustment: 1:00.

2.2.2.2 Each program running to finish, machine will stop gradually, TIME window display

END,O, beep sound with flash for 10 seconds, then all data return to ZERO and

resume to stand-by condition.