Dog trace d-control 1040 사용 설명서 - 페이지 12

{카테고리_이름} Dog trace d-control 1040에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dog trace d-control 1040 15 페이지. Electronic vibration training collar
Dog trace d-control 1040에 대해서도 마찬가지입니다: 매뉴얼 (18 페이지)

페이지 인쇄

Mode Press of the button Function

short/permanent

short

permanent

repetitive press

short

permanent

NOTICE: By modes 3 and 6 do not forget to switch off blinking by pressing

button. Modes 4–7 can be used for differing dogs in darkness.

Setting the modes: Press a dog selection button

button is paired with the required receiver) until symbol 1 or 2 starts flashing on the

LCD. Set the required mode number (0–7) using the buttons with the arrows

Confirm the selection by pressing button

transmitter allows you to set a different interval of flashing when using two collars

at the same time so you can easily spot your dogs according to the flashing interval

(example: dog 1 – mode 1 and dog 2 – mode 6).

Control buttons

The buttons are used for quick setting of vibration and light modes which are

displayed on the LCD in numbers 0–4 (vibration modes) and 0–7 (light modes).

Control buttons

The buttons are used for dog selection. A different impulse level can be set for each

dog. It remains saved even after selection switching to the other dog.

Light mode selection

1× single flash

flashing as long as the button is pressed

10× flashes

shines as long as button pressed and follows

10× flashes

stops the function ahead of time

1× flash every 0,5 seconds

shines as long as button pressed and follows 1× flash

every 0,5 seconds

same function as mode 0 with a different flashing

frequency

same function as mode 1 with a different flashing

frequency

same function as mode 2 with a different flashing

frequency

same function as mode 3 with a different flashing

frequency

(depending on which

again. The