Dog trace d-control 1040 Instrukcja obsługi - Strona 12
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Produkt do pielęgnacji zwierząt domowych Dog trace d-control 1040. Dog trace d-control 1040 15 stron. Electronic vibration training collar
Również dla Dog trace d-control 1040: Podręcznik (18 strony)
Drukuj stronę
Mode Press of the button Function
0
short/permanent
1
short/permanent
2
short
2
permanent
repetitive press
3
short
3
permanent
4
5
6
7
NOTICE: By modes 3 and 6 do not forget to switch off blinking by pressing
button. Modes 4–7 can be used for differing dogs in darkness.
Setting the modes: Press a dog selection button
button is paired with the required receiver) until symbol 1 or 2 starts flashing on the
LCD. Set the required mode number (0–7) using the buttons with the arrows
/
Confirm the selection by pressing button
transmitter allows you to set a different interval of flashing when using two collars
at the same time so you can easily spot your dogs according to the flashing interval
(example: dog 1 – mode 1 and dog 2 – mode 6).
Control buttons
The buttons are used for quick setting of vibration and light modes which are
displayed on the LCD in numbers 0–4 (vibration modes) and 0–7 (light modes).
Control buttons
The buttons are used for dog selection. A different impulse level can be set for each
dog. It remains saved even after selection switching to the other dog.
26
Light mode selection
1× single flash
flashing as long as the button is pressed
10× flashes
shines as long as button pressed and follows
10× flashes
stops the function ahead of time
1× flash every 0,5 seconds
shines as long as button pressed and follows 1× flash
every 0,5 seconds
same function as mode 0 with a different flashing
frequency
same function as mode 1 with a different flashing
frequency
same function as mode 2 with a different flashing
frequency
same function as mode 3 with a different flashing
frequency
or
(depending on which
or
again. The