Dog trace d-control 640 사용 설명서 - 페이지 11

{카테고리_이름} Dog trace d-control 640에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dog trace d-control 640 15 페이지. Electronic vibration training collar
Dog trace d-control 640에 대해서도 마찬가지입니다: 매뉴얼 (18 페이지)

페이지 인쇄

9.1 Transmitter – button functions

Audible beep tone

When pressing the button for beep tone, the receiver on dog's collar begins to emit

an audible beep tone (an acoustic signal). This command can precede a vibration

impuls. It is also a very effective warning tool. You can use the acoustic signal

instead of the command: Come!/Heel! In this case it replaces a whistle, the dog

always perceives its sound in the same intensity. It's very important always to use

the beep sounds in the same way in order not to confuse your dog. While

transmitting the audible beep tone, the green LED indicator of the receiver is

emitting a light.

Vibration

The vibration serves mainly to draw attention of sensitive dogs or training dogs

with impaired hearing. Provides a discreet recall of the dog, which is with deaf dogs

virtually impossible. It provides the ability to distract dog from undesirable activities

with moment of surprise. Each mode can mean different commands, depending on

your training. It can also substitute teaching method using the „clicker" and treats.

Mode

Function

short vibration

vibrates as long as you keep the button pressed

series of interrupted vibrations

vibrates interruptedly as long as you keep the button

pressed

vibrates permanently and releases a sound signal

Mode setting is done by using buttons

LCD, transmission of the vibration is made by pressing the button

Transmission symbol appears on the remote controller LCD and a red LED on the

receiver is lit permanently.

Light

For an easy localization of your dog in the dark, this function provides 8 different

modes of LED light. The LED - diodes are placed in the transparent receiver housing

of the collar.

Vibration mode selection

. Choosen mode is displayed on