Dog trace d-control 640 사용 설명서 - 페이지 9

{카테고리_이름} Dog trace d-control 640에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dog trace d-control 640 15 페이지. Electronic vibration training collar
Dog trace d-control 640에 대해서도 마찬가지입니다: 매뉴얼 (18 페이지)

페이지 인쇄

8.1 Pairing of the button

1. Turn ON your transmitter.

2. The receiver has to be turned OFF.

3. Press the button

4. Move the lower part of the transmitter to the target on your receiver (see the pic.

on page 22) and hold in position so the green LED is steadily lit. After

approximately 5 seconds it will switch to the pairing / programming mode,

indicated by flashing of the red and green LED at the same time (4x).

5. Then take your transmitter away from the receiver and press down the audible

beep tone button

has been successful.

8.2 Pairing of the button

Press the button

first receiver above (this can be followed when you use d-control 640, 1040, 1640

with a new purchased receiver).

8.3 Reprogramming of your receiver

The receiver can be programmed repeatedly without restraint using the same

transmitter or another (see the section 8 Programming (coding) the transmitter

with the receiver).

TIP: It is possible to program an unlimited number of receivers to a one

transmitter.

Example: Button

one or we can set all 3 in pairing regime and then press button for audible beep

tone. All these receivers will perform the same action at the same time when

pressing function button. This can be used for two collars on the neck of one dog,

or for the training of higher number of dogs, where we give the same commands to

all of them at the same time.

8.4 Fitting the collar

The strap with the receiver (receiver collar) must be tightened enough so that the

contact points are in contact with the skin of the dog. We recommend you to fit the

collar on the standing dog. When you can fit two fingers between the collar and your

dog's neck, the collar with the receiver are tightened enough. If a dog has long or

thick hair, it is suitable to trim the hair in the area of the contact points or to switch to

the longer contact points to ensure a consistent contact.

with the first receiver

for the first receiver choice.

on your transmitter. If you hear the beep tone the pairing

with the second receiver

for the second receiver choice and follow the steps as for the

is paired with 3 receivers, they can be programmed one by