Dog trace d-control easy 서비스 지침 매뉴얼 - 페이지 10
{카테고리_이름} Dog trace d-control easy에 대한 서비스 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dog trace d-control easy 18 페이지. Electronic training collar
페이지 인쇄
REPROGRAMMING OF YOUR RECEIVER
The receiver can be programmed repeatedly without restraint either using the same remote controller
or with another (see the section Programming (matching) of your remote controller and receiver).
TIP
It is possible to program an unlimited number of receivers to one receiver, which is
possible to use for common training of several dogs. It is possible to record two transmit-
ters into one receiver, which the instructor can use, for instance, for a potential correction
of the dog training.
How to use the remote controller
The DOGtrace™ d–control EASY remote controller is designed for interaction with one receiver.
Button
– sound signal
When you press down the sound signal button, you will be able to send the sound signal to your
receiver within a great distance. There is no time limit for this function: The buzzer will sound for as
long as you are holding the pressed down button and the green LED on your receiver will be
permanently lit.
Buttons
to
By pressing down this button, you will send your dog an alert in the form of electronic pulses
transmitted by the two electrodes located in the receiver collar, being generated all the time you are
holding the pressed down button, however, restricted for 8 seconds at the most.
The transmission will be indicated by the red LED on your receiver that will be lit as long as you are
pressing down the buttons for electric pulses.
Level 1: very weak pulse
Level 4: strong pulse
10
Level 2: weak pulse
Level 5: very strong pulse
Level 3: medium strong pulse
Level 6: the strongest pulse