Dogtra 1400NCP Series 소유자 매뉴얼 - 페이지 13

{카테고리_이름} Dogtra 1400NCP Series에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dogtra 1400NCP Series 17 페이지. Remote controlled dog training collars
Dogtra 1400NCP Series에 대해서도 마찬가지입니다: 설정 매뉴얼 (6 페이지)

페이지 인쇄

TESTING

TESTING YOUR

COLLAR

1. Turn the collar on by pressing the button

on the back side of the collar receiver.

The indicator light will come on for a

moment then blink once every two

seconds, showing that the collar is ready

to use. (If the indicator light is not green

but amber or red, the batteries need to be

charged.) Place the test light on the

contact points of receiver and hold it

there.

2. Watch the test light as you push the "Nick"

button on the transmitter. It should light for

just a moment.

3. Watch the test light as you push the

"Constant" button on the transmitter. It

should glow brightly. As a safety feature,

the collar receiver will automatically shut

off stimulation if the constant button is

depressed for twelve seconds or longer.

4. Change the intensity dial on the transmitter

clockwise and then counterclockwise. The

test light should glow brighter with higher

levels of stimulation and dimmer with

lower levels.

NOTE : It is normal for the test light not to

come on if the intensity level is set below

level ten.

5. Pressing the "Pager" button on the side of

the transmitter causes the collar to vibrate

for up to twelve seconds. The collar will

reactive when you push the button again.

TESTING