Akrobat GRASSHOPPER 설치 및 사용자 설명서 - 페이지 5

{카테고리_이름} Akrobat GRASSHOPPER에 대한 설치 및 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Akrobat GRASSHOPPER 16 페이지.

3. ASSEMBLY AND INSTALLATION

We recommend at least two people to assemble the trampoline. Use gloves to protect your hands from pinch points and

sharp points during assembly. Do not apply excessive force during assembly that will cause damage to the product.

TOOLS: You will need a cross-head screwdriver for the retaining wall PVC panels.

Lay all the frame parts on the ground with the

spring holes facing upwards as pictured below.

Push all frame parts together until all are fully

mated together.

Please note: On the long sides, the frame will appear to bow outwards - this is by design. When the springs are attached

the frame will pull inwards, but always have a slide outward bow.

Important: all trampoline sizes are approximate and can be up to +/- 3" (2.5 cm) different to those that we

publish.

Fitting the mat and installing the springs

Lay the mat flat inside the frame. Make sure the

logo is facing upwards. In order to make the

installation of the jumping mat easier, locate the

four rings in the cornersof the jumping mat and

attach four springs on these locations first. Then

continue by attaching springs from the corners

to the middle of the jumping mat until all springs

are attached.

At first, it may look like the mat won't fit, it will

however stretch to the correct size when you

finish attaching all springs.

After joining all the frame parts, install the trampoline legs

into the sockets on the frame.

Note: The frame will get its final shape after the jumping

mat is installed.

AKROBAT HINT:

Springs can be hard to attach, you will need a little force. Help

yourself by using one spring to pull another towards the frame

holes. Do not forget to wear gloves!

Important: Be sure all spring hooks

are well attached to the frame.