Dogtrace d-control easy 사용자 설명서 - 페이지 11

{카테고리_이름} Dogtrace d-control easy에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dogtrace d-control easy 19 페이지. Electronic training collar

How to check that your d–control works correctly

You can check anytime whether your set works correctly. Before the check, make sure that the

receiving collar is turned off.

Connect the leads of the testing discharge lamp to both contact points (loosen up the contact



points, insert the wires of the lamp under them so that they can be firmly held and then retighten

the contact points).

Turn on your remote controller and receiver.



Press down the button for sending a stimulation impulse. The testing discharge lamp will indicate



the receipt of the signal by a blink. The alteration of the intensity of the pulses according to options

1 to 4 will be indicated by a weaker or stronger light of the lamp.

At this moment, the stimulation impulse is only indicated by the light of the test discharge lamp, i.e.



the contact points do not emit any stimulation impulse.

Figure indicating the test lamp attached