DogWatch Performance Series 소유자 매뉴얼 - 페이지 4

{카테고리_이름} DogWatch Performance Series에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DogWatch Performance Series 13 페이지. Hidden fence systems
DogWatch Performance Series에 대해서도 마찬가지입니다: 소유자 매뉴얼 (14 페이지), 설치 매뉴얼 (10 페이지), 소유자 매뉴얼 (16 페이지)

페이지 인쇄

boundary wire is broken or the signal is interrupted, the Loop indicator light will go

out and an audible warning will sound. If the Loop light is out, consult your Dealer.

You should also check around your property for a visible broken wire.

6. Loop Monitor Display (LMD): The Loop Monitor Display provides a visual

indication of the status of your boundary signal. On traditional boundary wire

configurations each number on the scale represents the boundary signal distance

in feet, that is being broadcast from each side of the wire. A significant change

(drop) in signal range could indicate a partial wire break or other boundary wire

problem. Contact your dealer for troubleshooting tips or to schedule an

appointment.

Note: For non-traditional wire configurations where the boundary wires may be

close to one another, the LMD may not measure the boundary signal accurately in

feet, but is a visual setting reference point. Your DogWatch dealer will explain the

LMD setting and your actual signal range.

7. Range: The radio signal is transmitted from the boundary wire in all directions. The

signal is adjusted by the range control on the transmitter to create a signal field on

each side of the wire. The recommended signal field width is 6-10 feet. Your

DogWatch Dealer will adjust the radio signal distance according to the personality

and traits of your dog. Consult your DogWatch Dealer first before making any

adjustments yourself.

Signal Field: The signal field has two areas. When your dog first enters the signal

field, he will receive an audible warning. If he continues further into the signal field,

he will receive a correction. The audible area is approximately the first 13% of the

total signal field. To prevent your dog from entering the signal field and remaining in

the audible area causing depletion of the battery, the receiver will transition from an

audible warning to a short warning correction after a period of 15 seconds. This will

activate regardless of the mode switch setting, but will not activate if the receiver is

in the "Audible Only" Training Level (see Phase 1: page 15).

8. Training Mode: The training mode switch allows you to choose between two pet

friendly training options: Basic (Mode A) and QuickAlert

Basic setting, your pet will receive an audible warning followed by a correction. For

harder to train dogs, when set to QuickAlert, your pet will receive a very quick

"alert" correction followed by the normal audible warning and correction.

If you have multiple dogs on the system, when you set the training mode on the

transmitter, it will effect all receivers.

9. Rate: This adjusts to three levels (1 = slow, 2 = medium, 3 = fast). When your dog

gets a correction, he receives it in a series of pulses. Increasing the Rate means

that he will receive a greater number of pulses per second. The Rate feature

operates when your Receiver Training Level is set to Level 1, 2, or 3.

See the Receiver Levels and Transmitter Settings chart on page 9.

Note: On the back of the transmitter are four small switches. These switches

set your transmitter to the correct broadcast frequency. Your dealer will set

these switches for your system.

Do NOT change these settings. They are for DEALER USE ONLY.

(Mode B). When in the

R7 and R8 Receiver Features

The lightweight radio receiver worn by the dog identifies the coded FM radio signal from

the boundary wire. It creates an audible warning followed by stimulation if he comes too

close to the boundary wire. It operates on a replaceable battery and is waterproof when

the battery cap is securely fastened.

Adjustable

Nylon

Collar

Battery Cap

3.6 Volt Battery (R8)

Adjustable Collar: Your receiver comes fitted to an adjustable nylon collar. The

collar should be positioned above the dog's regular collar. The collar should be

adjusted to insure that the contact posts touch the skin on the dog's neck. Check the

fit for the first few days of wear to insure that the collar is not too tight or causing

irritation to your pet's neck.

DogWatch recommends that you remove the collar at night while your pet is inside.

SafeLink

Digital FM Design: Our patented FM design allows the DogWatch

receiver to recognize and activate only to our unique radio signal. This protects your

pet from unintentional correction caused by stray radio signals which may be emitted

by other electronic devices.

AutoMemory™: Our patented AutoMemory feature automatically adjusts the

correction level of the receiver when your pet challenges the boundary. When the

receiver is set to one of the AutoMemory levels, and the dog enters the signal field,

the dog will receive the correction of the initial setting. If your dog leaves the signal

field, the receiver will automatically advance the correction level setting by one, and

only one level. If the dog does not re-enter the signal field within the next 24-hour

period, the receiver defaults to the original setting. The AutoMemory feature operates

when your Receiver Training Level is set to 4, 5, or 6.

astReact™ Time: The DogWatch receiver offers the fastest reaction time available

in the pet containment industry. Whether your dog, strolls, runs or sprints into the

Avoidance Zone, the receiver will react — and correct — within 1/8 of a second (.125).

Automatic Shutdown: The DogWatch system is designed to protect your dog from

an over-correction in the unlikely event that your dog gets caught in the signal field. If

your dog does not exit the signal field, the receiver will automatically stop correcting

after 15 seconds — protecting your dog from over-correction. The receiver will

automatically reset once the dog leaves the signal field.

CollarBone: The CollarBone, metal lock washers and contact posts fasten the

receiver to the nylon collar. The plastic "collar bone" is designed to fit two collar

Contact Posts

Metal Lock

Washer

CollarBone

Test Light

Magnet

Hold Magnet Between Two Lines