DogWatch Performance Series Manuel du propriétaire - Page 4
Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} DogWatch Performance Series. DogWatch Performance Series 13 pages. Hidden fence systems
Également pour DogWatch Performance Series : Manuel du propriétaire (14 pages), Manuel d'installation (10 pages), Manuel du propriétaire (16 pages)
Imprimer la page
boundary wire is broken or the signal is interrupted, the Loop indicator light will go
out and an audible warning will sound. If the Loop light is out, consult your Dealer.
You should also check around your property for a visible broken wire.
6. Loop Monitor Display (LMD): The Loop Monitor Display provides a visual
indication of the status of your boundary signal. On traditional boundary wire
configurations each number on the scale represents the boundary signal distance
in feet, that is being broadcast from each side of the wire. A significant change
(drop) in signal range could indicate a partial wire break or other boundary wire
problem. Contact your dealer for troubleshooting tips or to schedule an
appointment.
Note: For non-traditional wire configurations where the boundary wires may be
close to one another, the LMD may not measure the boundary signal accurately in
feet, but is a visual setting reference point. Your DogWatch dealer will explain the
LMD setting and your actual signal range.
7. Range: The radio signal is transmitted from the boundary wire in all directions. The
signal is adjusted by the range control on the transmitter to create a signal field on
each side of the wire. The recommended signal field width is 6-10 feet. Your
DogWatch Dealer will adjust the radio signal distance according to the personality
and traits of your dog. Consult your DogWatch Dealer first before making any
adjustments yourself.
Signal Field: The signal field has two areas. When your dog first enters the signal
field, he will receive an audible warning. If he continues further into the signal field,
he will receive a correction. The audible area is approximately the first 13% of the
total signal field. To prevent your dog from entering the signal field and remaining in
the audible area causing depletion of the battery, the receiver will transition from an
audible warning to a short warning correction after a period of 15 seconds. This will
activate regardless of the mode switch setting, but will not activate if the receiver is
in the "Audible Only" Training Level (see Phase 1: page 15).
8. Training Mode: The training mode switch allows you to choose between two pet
friendly training options: Basic (Mode A) and QuickAlert
Basic setting, your pet will receive an audible warning followed by a correction. For
harder to train dogs, when set to QuickAlert, your pet will receive a very quick
"alert" correction followed by the normal audible warning and correction.
If you have multiple dogs on the system, when you set the training mode on the
transmitter, it will effect all receivers.
9. Rate: This adjusts to three levels (1 = slow, 2 = medium, 3 = fast). When your dog
gets a correction, he receives it in a series of pulses. Increasing the Rate means
that he will receive a greater number of pulses per second. The Rate feature
operates when your Receiver Training Level is set to Level 1, 2, or 3.
See the Receiver Levels and Transmitter Settings chart on page 9.
Note: On the back of the transmitter are four small switches. These switches
set your transmitter to the correct broadcast frequency. Your dealer will set
these switches for your system.
Do NOT change these settings. They are for DEALER USE ONLY.
TM
(Mode B). When in the
4
R7 and R8 Receiver Features
The lightweight radio receiver worn by the dog identifies the coded FM radio signal from
the boundary wire. It creates an audible warning followed by stimulation if he comes too
close to the boundary wire. It operates on a replaceable battery and is waterproof when
the battery cap is securely fastened.
Adjustable
Nylon
Collar
Battery Cap
3.6 Volt Battery (R8)
Adjustable Collar: Your receiver comes fitted to an adjustable nylon collar. The
collar should be positioned above the dog's regular collar. The collar should be
adjusted to insure that the contact posts touch the skin on the dog's neck. Check the
fit for the first few days of wear to insure that the collar is not too tight or causing
irritation to your pet's neck.
DogWatch recommends that you remove the collar at night while your pet is inside.
SafeLink
®
Digital FM Design: Our patented FM design allows the DogWatch
receiver to recognize and activate only to our unique radio signal. This protects your
pet from unintentional correction caused by stray radio signals which may be emitted
by other electronic devices.
AutoMemory™: Our patented AutoMemory feature automatically adjusts the
correction level of the receiver when your pet challenges the boundary. When the
receiver is set to one of the AutoMemory levels, and the dog enters the signal field,
the dog will receive the correction of the initial setting. If your dog leaves the signal
field, the receiver will automatically advance the correction level setting by one, and
only one level. If the dog does not re-enter the signal field within the next 24-hour
period, the receiver defaults to the original setting. The AutoMemory feature operates
when your Receiver Training Level is set to 4, 5, or 6.
astReact™ Time: The DogWatch receiver offers the fastest reaction time available
in the pet containment industry. Whether your dog, strolls, runs or sprints into the
Avoidance Zone, the receiver will react — and correct — within 1/8 of a second (.125).
Automatic Shutdown: The DogWatch system is designed to protect your dog from
an over-correction in the unlikely event that your dog gets caught in the signal field. If
your dog does not exit the signal field, the receiver will automatically stop correcting
after 15 seconds — protecting your dog from over-correction. The receiver will
automatically reset once the dog leaves the signal field.
CollarBone: The CollarBone, metal lock washers and contact posts fasten the
receiver to the nylon collar. The plastic "collar bone" is designed to fit two collar
Contact Posts
Metal Lock
Washer
CollarBone
Test Light
Magnet
Hold Magnet Between Two Lines
5