DogWatch System 1200 설치 매뉴얼 - 페이지 6

{카테고리_이름} DogWatch System 1200에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DogWatch System 1200 10 페이지. System
DogWatch System 1200에 대해서도 마찬가지입니다: 사용 설명서 (16 페이지), 소유자 매뉴얼 (12 페이지), 사용 설명서 (9 페이지)

페이지 인쇄

INSTALLING

1. Determine where you want the inside edge of the signal field to be and mark it with your training

flags. Flags should be 10ft apart. They mark the edge of the signal field and act as a visual aid

for both you and your dog during training.

2. The wire can be buried by cutting a 3 to 4" deep narrow groove using a spade or lawn edger.

The wire can also be clipped to fences, walls etc or passed through hedges or even loose laid on

the ground.

3. Place the boundary wire in the groove and cover it completely.

4. Join each end of the twisted wire to the each end of the boundary wire using the yellow

connectors (see diagram at back for use).

5. When crossing driveways, paths etc tarmac and concrete should have a ½" deep cut made

across them with an angle grinder the cable laid in the cut and sealed with a suitable sealant. For

gravel drives lay the wire inside a hose pipe and bury 4" down.

6. Testing: Turn the power switch on the red power light will come one and the green loop light will

be on and constant. PLEASE NOTE: in the video supplied the green loop light is flashing,

since making this video DogWatch have added a software upgrade and the loop light no

longer flashes.

7. Test the radio signal by carrying the receiver collar with the test light towards the boundary wire -

repeat this several times around the boundary. From Jan 2012 the test lamp and the collar

wrench has been combined into one unit. The image below shows the new tester (as shown in

your handbook) but the DVD currently show the old style (torpedo test lamp).

Diagram to illustrate placing the tester over the

probes (this is the same for the R12 & R12m

receivers)