DogWatch IB-200 운영 지침
{카테고리_이름} DogWatch IB-200에 대한 운영 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. DogWatch IB-200 4 페이지.
페이지 인쇄DogWatch
Product Features and Operating Instructions
IB-200 T
RANSMITTER
T
OP
Power Status Light
B
OTTOM
Frequency
Signal Range
(for Dealer Use Only)
EXT WIRE
INT - Wireless
Boundary wire
EXT - Wired
attachment
Set Up: Wireless / With Wire
The INT/EXT switch on the back of the unit allows you to choose your preferred application. You cannot use
both applications at the same time.
Wireless: When using the IB-200 as a wireless unit (
The signal range can be adjusted up to a maximum of 10 feet in diameter (5 feet in all directions from the
transmitter). Avoid placing the transmitter on or near large metal objects.
With Wire: When using the boundary wire (
and adjust the signal range using both the Signal Range adjustment and by increasing or
decreasing the distance between the separated wires. See instructions on page 3.
®
IB-200
200 is a dual function transmitter designed to be used either
The IB-
as a wireless unit that emits a signal directly from the transmitter
without the use of a boundary wire o o r r it may be installed with a
boundary wire to establish larger or multiple avoidance areas.
Power Status Light
The Power Status Light on the top of the transmitter turns "on" and glows
green when the transmitter is plugged-in and sending a signal. When using
a boundary wire, the Power Status Light turns "on" only when there is a
continuous sign l loop. See instructions on page 3.
Note: The green light may be steady green or blinking green. This depends
of the Frequency setting of the transmitter.
Signal Range
Signal range is the distance the signal radiates from the transmitter or
the boundary wire.
Turn the knob toward the '+' to increase the signal range.
•
This increases the size of the signal field.
Turn the knob toward the '-' to decrease the signal range.
•
This decreases the size of the signal field.
Never adjust the signal range while your pet is wearing the receiver
collar.
lways test the signal field and mark the edge of the field with
warning flags before allowing your pet near the boundary area.
Frequency
This switch controls the broadcast frequency of the signal. Your Dealer will
set this switch for your system. Do
DEALER USE ONLY
INT allows you to use the transmitter as a wireless unit.
EXT allows you to use the transmitter with boundary wire.
)
, you can customize your avoidance zone(s)
EXT
NOT
.
)
, place the unit in the area that you want your pet to avoid.
INT
1
change this setting. It is for
®