DogWatch IB-200 운영 지침 - 페이지 2
{카테고리_이름} DogWatch IB-200에 대한 운영 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. DogWatch IB-200 4 페이지.
페이지 인쇄Installation
The IB-200 transmitter emits a radio signal that is detected by the receiver collar worn by your pet. As your pet
approaches the signal field of the boundary area, the receiver collar begins to emit an audible warning beep. If
your pet goes beyond the warning zone, the audible warning is quickly followed by a mild 'correction' - - an
unpleasant, but safe, sensation from the receiver collar. With proper training, your pet will quickly learn to stay
away from areas that he associates with the audible warning.
E E s s t t a a b b l l i i s s h h i i n n g g t t h h e e B B o o u u n n d d a a r r y y A A r r e e a a
The IB-200 can be used to train your pet to stay within an area or to avoid an area. Set the signal range then
place the transmitter in the center of the area where you want to create a signal field or a boundary you do not
want your pet to cross. [
Wireless (No Boundary Wire)
T
RANSMITTER
Place the transmitter in the center of
the boundary area. For example,
under a piece of furniture, on a
counter or near a doorway.
Increase or decrease the
range to make the area
larger or smaller.
Wired Installation
The boundary wire allows you to isolate one or more avoidance areas within your house that are off-limits to
your pet. Follow these general guidelines when placing the boundary wire.
All wires should be placed so that they do not
I
interfere with normal household activities.
Carefully plan the location where you want to
I
create the signal field(s) (see diagram). Boundary
wire that is not separated to create a signal field
may emit a slight radio signal which could
activate the receiver collar if your pet lies directly
on top of the wire.
Do not install boundary wires next to baseboard
I
heating units as the heating units could pick up
the radio signal.
: Do not set the transmitter on or near large metal objects.]
NOTE
BOUNDARY AREA
(S
C
Z
ORRECTION
ONE
A
W
Z
UDIBLE
ARNING
ONE
Multiple Boundary Areas Loop
Unseparated boundary
wire (no signal)
2
B
F
OUNDARY
Place flags around edge of the
audible warning zone to mark
the boundary area. Gradually
remove the flags after your
pet is trained.
F
)
IGNAL
IELD
SAFE AREA
Transmitter
Signal Fields
LAGS
Single Area Loop
Twisted end of
boundary wire