ASG BLC-8020 운영 및 유지보수 매뉴얼 - 페이지 7

{카테고리_이름} ASG BLC-8020에 대한 운영 및 유지보수 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ASG BLC-8020 10 페이지. Brushless full auto shut-off

1. Full auto shut-off screwdriver

The screwdriver stops automatically when the screw has been tightened to the set-up torque level.

(1) Trigger switch

The LED lights are on when the trigger switch has been pressed approximately one-third down, and then the

screwdriver starts functioning when the switch trigger has been pressed half way down; the driver it stops when the

screw has been tightened to the set-up torque level.

(2) Forward / Reverse switch

When the switch is turned to the right as arrow indicates, the screwdriver will be fastening clock-wise; Vice versa, when

the switch is turned to the left, the screwdriver will be operating counter-clockwise. As the diagram shows, always set the

switch to neutral position when the screwdriver is not being used.

(3) LED light

While pressing the trigger, the LED lights up automatically.

(4) Bit Sleeve

To insert the bit, pull the bit sleeve away from the tool, and slide in the bit. After installing the bit please install the torque

cover as shown in the diagram below.