ASGCO U-Scrape 설치, 작동 및 유지보수 지침 - 페이지 6

{카테고리_이름} ASGCO U-Scrape에 대한 설치, 작동 및 유지보수 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. ASGCO U-Scrape 7 페이지. With bolt-up tensioner system

U-SCRAPE™ INSTALLATION

Step 4

Next insert the locking collar and the power arm,

and the machine screw & nut. Put on the end

caps, do this to both sides, tighten both lock

collars only.

Step 5

With an extra hand, have someone push the

U-Scrape cleaner up against the belt. Install

both springs, move the power arms downward

until there is some tension on the springs and

tighten the set screws on the power arm.

Step 6

To properly tension the U-Scrape, adjust

machine screw until each spring is extended

the distance listed in the chart, based on

your belt width.

OPERATION

Additional adjustments will be made on the nut for the machine screw that is attached to the spring.

If tube bushings are at the same location in relationship to the conveyor frame, both nuts need to be

tightened equally for even tension.

Test run the belt to see how well the cleaner is functioning.

www.asgco.com

800.344.4000

Machine Screw

Hanger & Nut

Power Arm

Spring

Downward

Spring Extension

Distance

Locking Collar

Spring Extension Distance

Belt Width

Distance

2-3/4"

2-15/16"

3-1/8"

3-3/8"

3-9/16"

3-7/8"

4-3/16"

4-9/16"

4-13/16"

4-15/16"