Doka 588676000 원본 사용 설명서 - 페이지 3
{카테고리_이름} Doka 588676000에 대한 원본 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Doka 588676000 18 페이지.
페이지 인쇄Original Operating Instructions Framax stripping corner I hydraulic
Intended use
The Framax stripping cylinder I is for hydraulic actua-
tion of the Framax stripping corner I.
With the 'Framax stripping corner I hydraulic', formwork
up to 5.40 metres high can be erected and stripped out
without the application of manual force.
Depending on requirements, the Framax stripping cyl-
inder can be combined with various hydraulic units and
accessories
Compatible hydraulic units
▪
Hydraulic unit Framax V4 with
- Cordless screwdriver 18 V (1800 rotation/min)
▪
Hydraulic unit V45 50/60Hz with
- System pressure controller Xclimb 60 V45
▪
Hydraulic unit SCP V1200 50/60Hz with
- Coupling adapter Framax stripping cylinder I
(intended use)
NOTICE
▪
Other use or use not in conformity with that
stated above is non-intended use and
requires the prior written approval of the
Doka company!
999239002 - 07/2018
Boundary conditions for use
NOTICE
The Framax stripping cylinder I is suitable for
deployment at outside temperatures
of between -5° C and +55° C.
Putting into service at temperatures below
-5 °C is not permissible, as the hydraulic oil
would be too viscous.
Maintenance & inspection
NOTICE
▪
Doka accepts no liability for products that
have been altered!
▪
Repairs may be carried out only by Doka or
specialist companies authorised by Doka!
▪
The Framax stripping cylinder I must be
inspected by an expert once a year.
Storage
NOTICE
To avoid damage, the drive components must
be stored in such a way that they are protected
against direct climatic influences and aggres-
sive substances.
3